Forums of the Megaverse®

Any body know if Splicers is out of its first printing yet.

Who cares?

The Baron of chaos wrote:Who cares?

Thought you were done with this forum.


Granted....so has everyone else lately.

I recieved the copy I ordered from Palladium a couple of days ago, and it was from the first printing. I assume that there is still only one printing of Splicers.

I'd think Splicers will stay 1st printing until after a couple of sourcebooks (yes I do know for fact they're being worked on) are released.

Ya, I still think they are on the first print. It has not been that long since it first comes out. On a side question, ruffly how many books do they usally print when a new book comes out the first time, for Palladium anyways?

Second Side Question - think they'll rush to get a second print ordered once the first goes out of stock?

I doubt they will order a second printing unless demand picks up, or a decently selling source book is released.

Jesterzzn wrote: or a decently selling source book is released.

Which they could easily do judging by some of the creativity expressed on these forums alone - the setting has plenty of milage left IMO.

sHaka wrote:

Jesterzzn wrote: or a decently selling source book is released.

Which they could easily do judging by some of the creativity expressed on these forums alone - the setting has plenty of milage left IMO.

I agree. A long way to go.

The Baron of chaos wrote:Who cares?

Well I care, thats who. I figure that if they are on there second printing, it might be a good sign that a sourcebook could be on it's way.